|

|
Just The Controls Needed For
The
Professionally-Disciplined Serious Attitude
|
>>
Mode
Select From 3
Modes Of Detector Operation. A
Three-Position Toggle Switch.
|
|
1)
IRON DISC -
Ignore Beeping On Iron
And Small "Trash" Metals |
|
2)
Normal -
Detect All Metals |
|
3)
AUDIO BOOST -
Increase Audio Output
Level |
|
>>
Tuning
Fine Tune The
Point Of The Audio Balance Level For
Maximum Audio-Detection Response. An
Absolute Must For The True
Disciplined Professional Technique
To Detecting Fine Sized Gold
Nuggets. |
|
>>
Mineralization
Select From
3 Modes Of Ground-Mineral-Effect
Balancing.
A Three-Position Toggle Switch
Used To Quickly Set The Ground
Mineral Effect Balancing Of The
Detector; As The Ground
Condition Changes Below The
Searchcoil.
|
|
1)
High
- Ground Contains High
Magnetic Mineral
Contains (Black Sand) |
|
2)
Normal -
Average Ground |
|
3)
Low - Very Low Or
No Magnetic Mineral
Contain In Ground |
|
>>
Ground
Reject
A Dual-Knob
Control Dial Which Provides Very
Precise Fine-Tuning Capability In
Balancing Out
Magnetic-Ground-Mineral-Effect. A
Small Fast Single-Turn Control-Knob
Is Stacked On A Large, 16-Turn Fine-Tuning
Control. |
|
>>
Sensitivity + Battery Test
A Dual Purpose
Dial Used To Set The Detector's
Sensitivity To The Level Of Signals
From Detected Metals Below The
Searchcoil. Plus, This
Control Is Used To Quickly Test The
Battery Power Level With a Simple
Audio Response Beep. |
|
>>
Power +
Volume
A Dial Used To Turn The System
On And Set The Audio Feedback Level
From The Built-In Loudspeaker. |
|
Note: Air Testing Is Not A Good Test Of A
Metal Detector's True Ability In Ground
Conditions. The Ability Of
Any Metal Detect Will Constantly Vary Second
By Second Depending On The Conditions Of The
Environment Below The Searchcoil; Including
Ground Mineral Type, Level Of Ground
Mineral, Presence Of Dirt, Length Of Time
The Item Was Buried, Age Of Item, Metal
Content Of Item, Magnetic Interferences,
Etc... |